The RX250AL Receiver logger is the heart of a GenII logging system. Because the RX250AL is responsible for receiving and storing the data, it is not necessary to have a PC permanently connected. The built-in battery means data logging is not interrupted even if there is a temporary AC mains failure. Multiple RX250ALs can be used for wide area coverage. Alarms (including SMS alarms) come as standard. (To use SMS alarms, a GSM modem is required).

Features

• Data Logger with integral receiver
• Alarm and GSM text output
• 24 hour built-in standby battery
• 247K readings expandable to 2M readings
• Dual RS232 serial ports
• Transmitter battery alarm
• Display and keypad for "online" metering
• Extensive communications options

Moxa

Ethernet/internet adaptor

The kit consists of the following:

• Moxa Nport 5110
• AC power supply
• Lead to connect to RX250

When installed, access to the Squirrel can be achieved via a virtual COM port connection, using an ethernet/internet connection.

GSMSQ

GSM Modem kit (logger / receiver side)

The kit consists of the following:

• Wavecom Xtend modem
• Mounting tabs
• Logger to modem lead (type GSM-mdm-com2X)
• Antenna with 1.8m lead
• SMA connector
• User instructions

When installed, access to the Squirrel can be achieved via a GSM network.
Note: GSM connectivity is not available with Darca Lite software.
A SIM card from the Network Service Provider is required.
The kit is necessary for text messaging functionality.

GSMPC

GSM Modem kit (PC side)

The kit consists of the following:

• Wavecom Xtend modem
• Antenna
• Modem to PC serial lead (type LC-PC/MDM)
• AC to 12V DC power supply (type MPGSMextend)
• User instructions

SQ/RS485

RS232 to RS485 interface converter

This unit converts the standard RC250 or Squirrel RS232 interface to a RS485 interface; thereby allowing equipment with the RS485 interface to communicate with the receiver/logger.

• Allows much longer cable lengths than RS232 - RC250/Squirrel can be further away from the PC or other connected equipment
• All RC250 units (after serial number T-25194) are compatible with this device

If you require a new logger to work with this interface, please specify at the time of ordering. Existing loggers may need a firmware update to work with the RS485 interface - please contact Eltek for advice.

Squirrels using this interface must be mains powered.